國立虎尾科技大學 |

Advances in energy power and automation engineering = select proceedings of the international conference, ICEPAE 2024 /

紀錄類型:	書目-語言資料,印刷品 : Monograph/item
正題名/作者:	Advances in energy power and automation engineering/ edited by Sanjay Yadav ... [et al.].
其他題名:	select proceedings of the international conference, ICEPAE 2024 /
其他題名:	ICEPAE 2024
其他作者:	Yadav, Sanjay.
團體作者:	Workshop on the Preservation of Stability under Discretization
出版者:	Singapore :Springer Nature Singapore : : 2025.,
面頁冊數:	xix, 589 p. :ill. (chiefly col.), digital ; : 24 cm.;
Contained By:	Springer Nature eBook
標題:	Electrical engineering - Dictionaries. -
電子資源:	https://doi.org/10.1007/978-981-96-9009-1
ISBN:	9789819690091

Advances in energy power and automation engineering = select proceedings of the international conference, ICEPAE 2024 /
Advances in energy power and automation engineeringselect proceedings of the international conference, ICEPAE 2024 /[electronic resource] :ICEPAE 2024edited by Sanjay Yadav ... [et al.]. - Singapore :Springer Nature Singapore :2025. - xix, 589 p. :ill. (chiefly col.), digital ;24 cm. - Lecture notes in electrical engineering,v. 14481876-1119 ;. - Lecture notes in electrical engineering ;v. 34 .

Part 1: Energy Utilization Management and System Optimization -- Sensitivity analysis of stratigraphic parameters on the yield of CO2 enhanced geothermal systems -- Temporal and spatial downscaling of wind forecast of new energy stations based on optimal frequency bias algorithm -- Study on signal noise reduction based on wavelet threshold technique -- Neural network PID-based frequency control strategy for energy storage participating loads -- A small sample load recognition method incorporating SE attention mechanism -- Research on Optimization Configuration of Distributed Integrated Energy System Based on Latin Hypercube Method -- Numerical simulation and defect optimization in CZTSSe solar thin-film cells implementing MoS2 as HTL layer -- The solar cell performance parameters of CuI as a hole transport layer were analyzed by SCAPS-1D -- The influence of two flow control methods on the anti wind sand erosion wear of airfoils -- Tannic acid/polyurethane laminated coatings for the stability of metal anodes in aqueous zinc-ion batteries -- Cost-benefit optimization analysis of proper utilization rate of provincial renewable energy -- Water partial discharge detection via interferometry -- Interactive management strategy of Virtual Power Plants based on Carbon Demand Response -- A multi-objective optimal scheduling method for the gas-steam-power system takes into account the exergy efficiency of iron and steel enterprises -- Load forecasting based on SABO-PSO-ELM hybrid algorithm -- Optimal Configuration Method of Power-Energy Hybrid Storage Systems for Renewable Power Plants -- Integrated optimal operation of rural microgrid production management considering photovoltaic outputs -- Part 2: Power System and Power Equipment Modeling -- Parameter identification for transformer winding equivalent networks based on an improved whale optimization algorithm -- Decoupled Spatial-Temporal Model for Temperature Field Prediction of Transformer -- The Differentiated Lightning Protection Modification of The Inlet Section Considering The Characteristic Change of The Station Lightning Arrester -- Automatic Classification of Substation Equipment Based on Multi-view Inspection Images -- Simulation research on distribution network based on improved transmission line decoupling method -- Recommended Protection to Prevent Safety Related Motors from Losing All AC Power When an Open Phase Fault Occurs in the Auxiliary Transformer of a Nuclear Power Plant -- Analysis of Load Characteristics of Floating Wind Turbines under Combined Wind and Wave Actions -- Improving Rotor-Angle Stability via Virtual Inertia Planning for Converter Interfaced Generations -- A Risk Assessment Model for the Impact of Insufficient Inertia on New Power Systems -- Research on optimal method of reactive power compensation for power grid based on risk assessment -- Analysis of the characteristics of 10kV line arrester discharge current under typical lightning strikes -- Research on the Application of Domestic Modeling and Simulation Platform in Nuclear Power Plants -- Optimization of Active Distribution Network Scheduling Based on Stackelberg Game -- Current Situation and Prospect of Impedance Spectroscopy and Its Application in Electric Power Equipment Oil's Performance Test -- A fault rate evaluation model of distribution network line under wind and rain hazards -- Voltage fluctuation solution and control strategy of traction network based on vehicle energy storage -- Research on Distributed Optimal Scheduling Technology for Distribution Networks with High-Proportion Photovoltaic Integration -- Research on the Application of Magnetic Network Approach in Magnetically-Saturated Controllable Reactors -- A Parallel 18-Pulse Rectifier Based on Power Electronic Transformer -- Splitting and Modularized Combination Approach of Power Distribution Terminal Services for Microservices Architecture -- Part 3: Mechatronics and Automation Control -- Trusted metering terminal and application design for distributed power supply -- A Study on Model Predictive Current Control Method for Permanent Magnet Synchronous Motors in Electric Aircraft -- GRU-DNN hybrid network for multi-factor electric vehicle energy consumption prediction -- Design of pressure monitoring system for push tool of avionics connector -- Super-Twisting Sliding Mode Controller Design for Permanent Magnet Synchronous Motor -- Research and Implementation of Automotive Power Seat Fault Detection System Based on LabVIEW -- Study on the jet behavior of the secondary oxygen nozzle of the secondary combustion oxygen lance in 260 t converter -- Study on Fault Diagnosis of Rolling Bearings Based on CNN-BiLSTM -- Numerical analysis and sensitivity study of friction parameters for high-temperature molten salt storage tanks -- A study of Low-voltage Distributed Photovoltaic Flexible Control Technology -- Simulation of Fault Current Characteristics in Ship Lock Motor based on Harmonic Analysis -- API Independent Pitch Control Strategy for Large Wind Turbines Considering Load Reduction -- Research on the Electronic Differential Control Strategy for Aerial Working Platforms Based on the Ackermann Model -- NVH Analysis of Rotor Step Skewing on Permanent Magnet Synchronous Motor -- Optimization of Oil Cavity Structure in Hydrostatic Bearings Based on Multi objective Particle Swarm Optimization Algorithm -- Research on Thermal Runaway Propagation Characteristics of a Battery Module with PCM and Aluminum Plate Fins Structure -- Hybrid Damping Control Strategy for LLCL Grid-connected Inverters under Weak Grids -- Research on Modulation Strategies for Permanent Magnet Synchronous Motors in Electric Vehicles.

This book features selected and expanded papers presented at the 2024 5th International Conference on Energy, Power, and Automation Engineering (ICEPAE 2024), held in Zhengzhou, China during May 24 to 26, 2024. It focuses on the research domains of energy science and engineering, electric power and electrical engineering, and automation engineering. The book showcases the latest advancements in renewable energy, power systems, smart grids, electric vehicles, control engineering, and industrial automation. The volume highlights progress in renewable power generation, electrical infrastructure, and automation technologies, offering engineers, scholars, and researchers' valuable insights and recent breakthroughs. It also seeks to inspire innovative solutions to pressing challenges in these fields.

ISBN: 9789819690091

Standard No.: 10.1007/978-981-96-9009-1doiSubjects--Topical Terms:

772070
Electrical engineering
--Dictionaries.

LC Class. No.: TK5

Dewey Class. No.: 621.3

Advances in energy power and automation engineering = select proceedings of the international conference, ICEPAE 2024 /
LDR:07654nam a22003495a 4500 001 1171714
003 DE-He213
005 20251121114927.0
006 m d
007 cr nn 008maaau
008 260504s2025 si s 0 eng d
020 $a 9789819690091 $q (electronic bk.)
020 $a 9789819690084 $q (paper)
024 7 $a 10.1007/978-981-96-9009-1 $2 doi
035 $a 978-981-96-9009-1
040 $a GP $c GP
041 0 $a eng
050 4 $a TK5
072 7 $a THR $2 bicssc
072 7 $a TEC031020 $2 bisacsh
072 7 $a THR $2 thema
082 0 4 $a 621.3 $2 23
090 $a TK5 $b .I61 2024
111 2 $a Workshop on the Preservation of Stability under Discretization $d (2001 : $c Fort Collins, Colo.) $3 527686
245 1 0 $a Advances in energy power and automation engineering $h [electronic resource] : $b select proceedings of the international conference, ICEPAE 2024 / $c edited by Sanjay Yadav ... [et al.].
246 3 $a ICEPAE 2024
260 $a Singapore : $c 2025. $b Springer Nature Singapore : $b Imprint: Springer,
300 $a xix, 589 p. : $b ill. (chiefly col.), digital ; $c 24 cm.
490 1 $a Lecture notes in electrical engineering, $x 1876-1119 ; $v v. 1448
505 0 $a Part 1: Energy Utilization Management and System Optimization -- Sensitivity analysis of stratigraphic parameters on the yield of CO2 enhanced geothermal systems -- Temporal and spatial downscaling of wind forecast of new energy stations based on optimal frequency bias algorithm -- Study on signal noise reduction based on wavelet threshold technique -- Neural network PID-based frequency control strategy for energy storage participating loads -- A small sample load recognition method incorporating SE attention mechanism -- Research on Optimization Configuration of Distributed Integrated Energy System Based on Latin Hypercube Method -- Numerical simulation and defect optimization in CZTSSe solar thin-film cells implementing MoS2 as HTL layer -- The solar cell performance parameters of CuI as a hole transport layer were analyzed by SCAPS-1D -- The influence of two flow control methods on the anti wind sand erosion wear of airfoils -- Tannic acid/polyurethane laminated coatings for the stability of metal anodes in aqueous zinc-ion batteries -- Cost-benefit optimization analysis of proper utilization rate of provincial renewable energy -- Water partial discharge detection via interferometry -- Interactive management strategy of Virtual Power Plants based on Carbon Demand Response -- A multi-objective optimal scheduling method for the gas-steam-power system takes into account the exergy efficiency of iron and steel enterprises -- Load forecasting based on SABO-PSO-ELM hybrid algorithm -- Optimal Configuration Method of Power-Energy Hybrid Storage Systems for Renewable Power Plants -- Integrated optimal operation of rural microgrid production management considering photovoltaic outputs -- Part 2: Power System and Power Equipment Modeling -- Parameter identification for transformer winding equivalent networks based on an improved whale optimization algorithm -- Decoupled Spatial-Temporal Model for Temperature Field Prediction of Transformer -- The Differentiated Lightning Protection Modification of The Inlet Section Considering The Characteristic Change of The Station Lightning Arrester -- Automatic Classification of Substation Equipment Based on Multi-view Inspection Images -- Simulation research on distribution network based on improved transmission line decoupling method -- Recommended Protection to Prevent Safety Related Motors from Losing All AC Power When an Open Phase Fault Occurs in the Auxiliary Transformer of a Nuclear Power Plant -- Analysis of Load Characteristics of Floating Wind Turbines under Combined Wind and Wave Actions -- Improving Rotor-Angle Stability via Virtual Inertia Planning for Converter Interfaced Generations -- A Risk Assessment Model for the Impact of Insufficient Inertia on New Power Systems -- Research on optimal method of reactive power compensation for power grid based on risk assessment -- Analysis of the characteristics of 10kV line arrester discharge current under typical lightning strikes -- Research on the Application of Domestic Modeling and Simulation Platform in Nuclear Power Plants -- Optimization of Active Distribution Network Scheduling Based on Stackelberg Game -- Current Situation and Prospect of Impedance Spectroscopy and Its Application in Electric Power Equipment Oil's Performance Test -- A fault rate evaluation model of distribution network line under wind and rain hazards -- Voltage fluctuation solution and control strategy of traction network based on vehicle energy storage -- Research on Distributed Optimal Scheduling Technology for Distribution Networks with High-Proportion Photovoltaic Integration -- Research on the Application of Magnetic Network Approach in Magnetically-Saturated Controllable Reactors -- A Parallel 18-Pulse Rectifier Based on Power Electronic Transformer -- Splitting and Modularized Combination Approach of Power Distribution Terminal Services for Microservices Architecture -- Part 3: Mechatronics and Automation Control -- Trusted metering terminal and application design for distributed power supply -- A Study on Model Predictive Current Control Method for Permanent Magnet Synchronous Motors in Electric Aircraft -- GRU-DNN hybrid network for multi-factor electric vehicle energy consumption prediction -- Design of pressure monitoring system for push tool of avionics connector -- Super-Twisting Sliding Mode Controller Design for Permanent Magnet Synchronous Motor -- Research and Implementation of Automotive Power Seat Fault Detection System Based on LabVIEW -- Study on the jet behavior of the secondary oxygen nozzle of the secondary combustion oxygen lance in 260 t converter -- Study on Fault Diagnosis of Rolling Bearings Based on CNN-BiLSTM -- Numerical analysis and sensitivity study of friction parameters for high-temperature molten salt storage tanks -- A study of Low-voltage Distributed Photovoltaic Flexible Control Technology -- Simulation of Fault Current Characteristics in Ship Lock Motor based on Harmonic Analysis -- API Independent Pitch Control Strategy for Large Wind Turbines Considering Load Reduction -- Research on the Electronic Differential Control Strategy for Aerial Working Platforms Based on the Ackermann Model -- NVH Analysis of Rotor Step Skewing on Permanent Magnet Synchronous Motor -- Optimization of Oil Cavity Structure in Hydrostatic Bearings Based on Multi objective Particle Swarm Optimization Algorithm -- Research on Thermal Runaway Propagation Characteristics of a Battery Module with PCM and Aluminum Plate Fins Structure -- Hybrid Damping Control Strategy for LLCL Grid-connected Inverters under Weak Grids -- Research on Modulation Strategies for Permanent Magnet Synchronous Motors in Electric Vehicles.
520 $a This book features selected and expanded papers presented at the 2024 5th International Conference on Energy, Power, and Automation Engineering (ICEPAE 2024), held in Zhengzhou, China during May 24 to 26, 2024. It focuses on the research domains of energy science and engineering, electric power and electrical engineering, and automation engineering. The book showcases the latest advancements in renewable energy, power systems, smart grids, electric vehicles, control engineering, and industrial automation. The volume highlights progress in renewable power generation, electrical infrastructure, and automation technologies, offering engineers, scholars, and researchers' valuable insights and recent breakthroughs. It also seeks to inspire innovative solutions to pressing challenges in these fields.
650 0 $a Electrical engineering $v Dictionaries. $3 772070
650 0 $a Renewable energy sources $v Congresses. $3 557962 $3 735565
650 1 4 $a Electrical Power Engineering. $3 1365891
650 2 4 $a Control, Robotics, Automation. $3 1365878
650 2 4 $a Energy Policy, Economics and Management. $3 784769
700 1 $a Yadav, Sanjay. $e editor. $3 1315546
710 2 $a SpringerLink (Online service) $3 593884
773 0 $t Springer Nature eBook
830 0 $a Lecture notes in electrical engineering ; $v v. 34 $3 773550
856 4 0 $u https://doi.org/10.1007/978-981-96-9009-1
950 $a Energy (SpringerNature-40367)